Sub Attribute Configuration can be used to create Configurations, which you want to apply to only one or few Families of specific Category / Categories.
Create Sub Attribute Configuration
Open the “Attribute Configuration Settings”
Select “+” that is located beside the general Attribute Configuration
3. Select categories
4. Select “ok”
The new Sub Configuration is created and the Configuration Editor window will appear:
6. Link Attributes. Read more Create New or Edit Revit Attribute Configuration
Key Attribute: The Sub-Configuration will be run at the same time as the general Attribute Configuration. You will not be able to set Key Attribute in the Sub-Configuration, since the synchronizing will use the Key Attribute set in the general Attribute Configuration.
7. Select “Close”
The Sub Configuration has now been setup as follows:
You are able to create as many of these Sub Configurations as you like.
Synchronizing Sub-Configuration
The next time you open the “Family Type <-> dRofus Item” window, it will be a "++" symbol next to the active Configuration, indicating that one or more Sub Configurations may be applicable if you were to run a Synchronization:
When synchronizing the Sub-configuration will only be used to send data to the families that is included in the categories you set in step 3.
Example:
We have set a configuration for Doors. We run a synchronizing including Doors and Chairs. The general Attribute Configuration will be used for both families but the Sub-Configuration will only be used for Doors.
Delete Sub Configuration
To delete existing Sub Configuration, click on the "-" button next to the Sub Configuration which you would like deleted:
