...
- Gross/Net Factor for the Functional Level
- Planned Areas (Gross and Net)
- Programmed (Briefed) Room Count and Net and Gross Areas
- Designed areas Gross and Net Areas
- Difference between Designed and Programmed Net and Gross Areas
1. The Gross/Net factor section provides an editable field to enter a Grossing factor (expressed as a ratio) to Planned or Programmed Functional Levels. For example to apply a Gross/Net factor of 20% to a Functional Level you enter "1.20" and this will show also as 20% in the adjoining field.
...
- Planned Net area (calculated from a given Planned Gross Area)
- Programmed (Briefed) Gross area (calculated from the Function Level Net Programmed Area)
- Delta values for Designed Gross (differences between Designed and Programmed Areas)
2. The Planned Areas section allows you to enter a Net and/or Gross Planned area for the selected Functional Level which in turn then calculates the other (Gross or Net) value according to the Gross/Net factor. Refer Warning panel below. For Planning Gross/Net Calculations the Gross/Net Factor should only be applied at one Functional Level, preferably the lowest Level if you need the same Grossing to appear for each Functional Level above.
3. The Programmed (Briefed) Areas section provides a summary of
...
This enables differing Grossing Factors to be applied to Functional Functional Levels as per the Project Design Programme (Brief) allowances for Circulation / Travel / Plant / Planning Contingencies / Wall thicknesses etc.
4. The Designed Areas Areas section which provides an editable field to enter a Gross Designed Area which is sourced by either
...
The Net area total is the sum of all Designed Rooms contained within the selected Functional Level.
5.Diff (Designed - Programmed section provides calculations of the difference between Disigned and Programed measurements in the Function Level
Note:
- areas for non-functional spaces (such as corridors and plant rooms) will also be included as part of the Net Area for Designed Areas.
- The Gross/Net factor for the Functional Level is not applied to the total of the designed areas. It only applies to Planned or Programmed Areas.
...